Bipolar 6mm Conductive Rubber Nipple Clamp Electrodes - Red

Supplied as a pair of bipolar nipple clamp electrodes.

Each pair of Bipolar Nipple Clamps will be printed in my trademark RED PLA. These clamps come with 6mm conductive rubber tubing that takes 2mm plugs fitted into the clamping jaws.

It will be dispatched with 6mm conductive rubber tubing already fitted unless you opt for an unassembled one. One side of each set of Conductive Rubber has blanking pins fitted to secure them in place and to prevent any chance of the two clamps shorting against each other. Your TENS cables plug secures the other end.

To use both sets of clamps, you will need an e-stim control box with two isolated channels to prevent any risk of the current going across the chest instead of just through each nipple.

Just plug in your 2mm plugs and then open up the clamp before pulling a nipple through the conductive rubber jaws. Then close the clamp and then tighten the knurled thumbscrews to apply the desired amount of pressure on your nipples. Then switch on your control box and experience some e-stim pleasure.

These clamps are perfect for larger nipples or for clamping down on the areola behind smaller nipples.

The large knurled thumbscrews are fitted to nylon nuts and bolts (colour may vary from that shown) that are used to tighten and hold the clamping jaws together. I used nylon fittings to isolate the two pieces of conductive rubber further to prevent the current using metal bolts as a shortcut.

You can see a XXX pic of this electrode (the yellow version) in use over on Fetlife.com (free account required).

Safety: Never put a current through the chest area. Always use a control box with isolated channels and use one channel on each nipple.