V2 Bipolar 6mm Conductive Rubber Nipple Clamp Electrodes 2mm Plug

Due to the small teeth on the clamping faces, these new nipple clamp electrodes are easier to fit in place and stay on better.

Supplied as a pair of nipple clamps.

These clamps come with 6mm conductive rubber tubing that takes 2mm plugs fitted into the clamping jaws.

One side of each set of Conductive Rubber has blanking pins fitted to secure them in place and prevent the two clamps from shorting against each other. Your TENS cables plug secures the other end. To use both sets of clamps, you will need an e-stim control box with two isolated channels to prevent the current from going across the chest instead of just through each nipple.

These two-part clamping arms allow me to add a splash of colour while making them more effective.

Nipple play is very intense, so once clamping is in place, go low and slow with the power levels.

Just plug in your 2mm plugs and open the clamp before pulling a nipple through the conductive rubber jaws. Then, close the clamp and tighten the knurled thumbscrews to apply the desired pressure on your nipples. Then switch on your control box and experience some e-stim pleasure. These clamps are perfect for larger nipples or for clamping down on the areola behind smaller nipples.

The large knurled thumbscrews are fitted to nylon nuts and bolts, which tighten and hold the clamping jaws together. I used nylon fittings to further isolate the two pieces of conductive rubber to prevent the current from using metal bolts as a shortcut.

Note: This product is supplied as is, and I am not liable for any problems that arise from its use. It is sold as a novelty item and carries no warranty. Your statutory rights remain. Images shown are renderings; the printed product will show some layer lines and require a light sanding.

Safety: Never put a current through the chest area. Always use a control box with isolated channels and one channel on each nipple.